Installation instructions

THE HIFI FRAME

Through the following 5 steps, you’ll attach The HiFi Frame securely to your TV and CANVAS speaker, ensuring a precise and seamless installation.

Parts in the box:

2 pcs. Horizontal frame profiles
2 pcs. Vertical frame profiles
4 pcs. Corner bracketswith screws
4 pcs. Corner bracketback plates
12 pcs. Tension Springs
8 pcs. 2 mm spacer
8 pcs. 3 mm spacer
8 pcs. 5 mm spacer
8 pcs. 10 mm spacer

Step 1 of 5

Determining spacer size

Begin by measuring the width of your TV in millimetres (TW). Subtract this measurement from the inner width of the frame (FW) and divide the result by two. This calculation determines the distance between the TV and the frame and helps you select the correct spacer size.

Frame inner width: (FW)

55": 1239 mm.
65": 1458 mm.
75": 1687 mm.
77": 1724 mm.
83": 1857 mm.
85": 1906 mm.

In most cases, the same spacer size can be used for both the vertical profiles and the top horizontal profile. Before securing the spacer, we recommend test-fitting it between the top frame and the TV while the adhesive backing is still covered.

If needed, two spacers may be combined (e.g. 2 mm. + 5 mm. to reach 7 mm.) to achieve the optimal fit. Position spacers near each corner, approximately 20-30 mm. from the edge.

Avoid placing spacers more than 60 mm. from the corners, as this may cause the frame to bend outward.

Step 2 of 5

Preparing the vertical profiles

With the correct spacers selected, mount the corner brackets to the top and bottom of both vertical frame profiles. Ensure that all brackets are oriented correctly and securely fastened before proceeding.

Step 3 of 5

Assembling the frame

Once the corner brackets are in place, insert the right vertical profile into the top horizontal profile and secure it with the screw.

Next, position the bottom horizontal profile beneath the CANVAS front grille, slide it into the right vertical profile, and tighten the screw to hold it in place.

Repeat step 3 for the left vertical profile.

Step 4 of 5

Final alignment

After assembling the main frame, slide the left vertical profile into both the top and bottom horizontal profiles and tighten the screws.

To achieve precise alignment, slightly loosen one corner at a time and adjust as needed until the frame sits evenly and symmetrically.

Step 5 of 5

Securing the frame

To ensure the frame sits flush against the TV and CANVAS speaker, install the tension clips on the rear of the frame. Insert one end of each clip between the frame and the back of the TV, then press and slide the opposite end into position, with both ends facing the frame.

Depending on the TV and frame size, use 3 to 4 clips on each side profile and along the top profile.

The bottom profile should remain free of clips.

Congratulations!

You have now successfully installed The HiFi Frame onto your TV and CANVAS speaker.